Over the last two or so weeks I completed the fabrication and match drilling of all the floor stiffeners as well as attached all the baggage stiffeners and covers layer out in the instructions. This now completes the fuselage to the point of complete disassembly, deburr , dimple, prime, etc. Not looking forward to this part, but it's necessary
I also fabricated a stiffener angle from scrap for the arm rests just as an extra insurance against deformation from myself or anyone climbing into or out of the cockpit. Accidents happens and it's best to give a little bit of support. Easy process. Note that one side of the angle had to be shortened from 3/4” to match up with the armrest flange.